TunerPro User Forum

If the car does not go in to the WOT map, what should I look at then? Tps? are there more then that?

Its a 325 NV 92 402 motronic 3.1

If the car does not go in to the WOT map, what should I look at then?

Its a 325 NV 92 402 motronic 3.1


Best regards

what is most beliveable that is wrong if the car is stoppes ignite after 5000rpm,,,

maf, tps or lambda sensor?

I have M3.1 BMW 325NV 92. Turbo, deka630, maf bigger, e85 fuel, 1bar. I have a perfect map but getting lean on full wot, even if i messing with my fuelpressure, the injector should manage the effect im at... If i want to go from lambda 1(AFR 9,7) to lambda 0,8 how/where do i change... what does the ...

100 Amplifier 1 in DME Control Unit
Read more at http://realitypod.com/2012/06/bmw-compl ... fcZGstd.99


what does amplifier 1 do?

restored ecu with error start up again and it is static


100 unknown Output fault
Error counter : 50
Engine speed 200.00 1/min
Load signal 1.50 ms
Hexcode=6462051E32 0.00 [HEX]
Short circuit to ground
Open circuit
Fault stored after de-bouncing delay
Error present
Static error

Gets this with new chip: E R R O R M E M O R Y --------------------------------------- Datum: 01.06.14 15:22 ECU: DM331K20 JobStatus: OKAY Variante: DM331K20 ------------------------------------------------------------- RESULT: : 3error in error memory ! ! -------------------------------------------...

1. I have a modded 403 chip for my hardware, but the box i have is 402. Can i have that?

2. If not. Can i put a 403 box on a 402 car?

3. if not can i convert the 403 chip to 402 program?

Please just give me a advice...!

Im using BMW_ecu402_soft599.xdf and it seems to be right but, however any advice if it is correct?

Need xdf file for BMW e36 325 m50 92, euro, m3.1(.1?)

Bosch Motronic

ecu
0261 200 402 Red Label


chip
27C256

1 267 357 098