Search found 4 matches
- Sun Apr 07, 2024 9:55 pm
- Forum: Bosch
- Topic: Extend tables size
- Replies: 34
- Views: 38375
Re: Extend tables size
Hi guys, back to table extension. What i noticed by expanding a table is: where NOT to put the new map. In my 404 dme, i put the new table to D180, right a few "empty" bits behind the "table of maps", what causes the engine to stall immediately. So my conclusion to this is, that ...
- Wed Feb 21, 2024 12:36 am
- Forum: General Tuning Discussion
- Topic: Newbie questions! RB26 wont start after swap to Link
- Replies: 1
- Views: 757
Re: Newbie questions! RB26 wont start after swap to Link
Hi there,
first: check basics
* can u see rpm signal in G4 while cranking?
* can u see signal from crank shaft sensor?
* can u see signal from cam shaft sensor?
* is the fuel pump priming?
* is there fuel spread by the injectors?
* is there a ignition spark?
Greets
first: check basics
* can u see rpm signal in G4 while cranking?
* can u see signal from crank shaft sensor?
* can u see signal from cam shaft sensor?
* is the fuel pump priming?
* is there fuel spread by the injectors?
* is there a ignition spark?
Greets
- Wed Dec 13, 2017 1:21 am
- Forum: Bosch
- Topic: Bosch BMW 0 261 200 402 ECU XDF file
- Replies: 12
- Views: 20336
- Tue Apr 05, 2016 11:40 pm
- Forum: Bosch
- Topic: Ecu not responding to changed ROM data...
- Replies: 1
- Views: 5500
Ecu not responding to changed ROM data...
Hi Guys, im not new to tuning but new to ecu tuning ;) Im trying to tune my BMW M60B40 engine with Bosch 404 ecu. Tunerpro and Ostrich 2.0 are ready. I read the original ROM and transefed it to Tunerpro, right xdf is loaded. Maps are looking good. If i copy the original content to the ostrich, the c...