HELP!!!

mikes87ttype · Post by **mikes87ttype** » Wed Feb 13, 2013 6:58 pm

New to this... I believe I have set my PC up correctly with TP. It shows that it reads the cables but when I plug it into my ecu it goes to hardware not found. I have an 87 buick GN or really its a T type but should be same thing. I really am just wanting to read and not burn anything at this time. I have downloaded the bin and xdf and even tried to download from the ecu but am so confused because it wont read anything right when i plug my cables into the car. Any Suggestions PLEASE???

Post by **robertisaar** » Thu Feb 14, 2013 7:37 am

to read the datastream, you need the correct ADS or ADX (depending on if you're running V4 or V5).

"hardware not found" is referring to emulation/burning hardware, not an ALDL cable, so that's normal.

1227730 IROC · Post by **1227730 IROC** » Fri Mar 22, 2013 4:07 pm

I downloaded .ads and .xdf definition files from the gm section in the tunerpro website and it fixed this problem.