To convert TPS volt to % I would simply multiply 5V by the desired TPS percentage (/100) to solve for new percent, correct?
Something like this:
5xdesired TPS %/100=new TPS percentage.
[edit]
I think I have to make the "5" to a smaller value, due to the usable range being less than 5 and then add an offset to the calulation.
[/edit]
The reason I ask is because the ALDL dash I will be using has only volts as a display, and everthing is defined as % in the xdf.
As a related note is there a way to change the displayed values in TP RT of the ALDL dash/values? I haven't found a way, other than moving over to Scanner Pro.
TPS calc
Moderators: Mangus, robertisaar, dex
You need to change the definition to change the displayed values and calculations.
To go from v to %, you need to take the raw ALDL value, divide by 255, then multiply by 100. Or, said differently, multiply the raw ALDL value by 0.3921569.
To go from v to %, you need to take the raw ALDL value, divide by 255, then multiply by 100. Or, said differently, multiply the raw ALDL value by 0.3921569.
***************************************
TunerPro Author
1989 Trans Am
TunerPro Author
1989 Trans Am
- Six_Shooter
- Posts: 590
- Joined: Sun May 06, 2007 7:32 am