Page 1 of 1
Project: Full XDF file for 403 ECU !!!
Posted: Wed Jun 08, 2011 12:55 pm
by aboutton
I am writing a new XDF file for BMW 403 ECU, you info contribution will be appreciated . (Email me if you would like to help)
Thanks for ( RevLimit )
(File too big to copy here)
Posted: Wed Jun 08, 2011 12:58 pm
by aboutton
Sorry but i noticed that i cannot paste the file in here cz it is to big, if you think you can help PM me your email address so i send you the file.
Posted: Sat Jun 11, 2011 2:08 pm
by Mangus
You could always send me the file and I can post it to the site.
Posted: Mon Jun 13, 2011 12:05 pm
by aboutton
anybody knows what the descriptors D2 D3 D4 and CB stands for ?
Posted: Mon Jun 13, 2011 11:07 pm
by revlimit
403 is very similar to 413 structure. So you can copy my ideas from comprihensive 413 XDF file that is posted in download section.
Posted: Wed Jun 15, 2011 12:20 pm
by aboutton
Revlimit
I already did that, but i'm stuck on couple maps, how can i send you the xdf file so you can check it out ?
Posted: Wed Jun 15, 2011 9:00 pm
by revlimit
I don't have time to check all the maps. You should make an XDF only of the maps that are needed for tuning. Having ALL maps on the XDF makes it look like more difficult.
Posted: Thu Jun 16, 2011 1:14 pm
by aboutton
you are right Revlimit but what i am trying to do is find out what does all the maps do so i can remove the unnecessary ones, like you did on the E30 ECU
Posted: Mon Jun 20, 2011 10:03 pm
by revlimit
The way you find out is you have to have ostrich2 emulator. Then you include all of the maps into one XDF, you don't have to figure out the load and rpm scales on all of the maps. Then you drive the car and one by one maps you hit trace to see of the ECU is reading any of the maps. Then you erase the ones that ECU never reads. So that way you only works with the maps that ecu uses.
Posted: Mon May 07, 2012 7:09 pm
by tunisianpower
hi , you can send me this XDF ? i have a 403ecu
Thanks
