mathematical issues
Posted: Thu Mar 03, 2016 9:01 pm
Lets start with why I have this question. I am working on developing support for the 88-91 preludes using the PK2 ecus. I have had a working mask for about two years, although limited to the six fuel tables, the six ignition tables, and the check sum on/off functionality. I took a break from this project for about 1.5 years other wise I believe I would have more.
The equation I am using for the fuel is D=(V*0.027)-(110.595*M)
The variables in this are D-duty cycle, V-raw table value in hex converted to decimal, and M-table multiplier.
In the PK2 ecus the table multiplier (M) is the first character on the left of the 16 bit fuel value. So for fuel value 6411, the 6 is the multiplier value (M).
So my question finally is, can I set tunerpro to only read the hex digit of the multiplier so I don't have to manually enter the value for M into the equation for each load cell as every cell has its own multiplier value unlike many popular Honda ECU codes.
I can't seem to find a way to set the definition of M to only read the first byte.
The equation I am using for the fuel is D=(V*0.027)-(110.595*M)
The variables in this are D-duty cycle, V-raw table value in hex converted to decimal, and M-table multiplier.
In the PK2 ecus the table multiplier (M) is the first character on the left of the 16 bit fuel value. So for fuel value 6411, the 6 is the multiplier value (M).
So my question finally is, can I set tunerpro to only read the hex digit of the multiplier so I don't have to manually enter the value for M into the equation for each load cell as every cell has its own multiplier value unlike many popular Honda ECU codes.
I can't seem to find a way to set the definition of M to only read the first byte.