JPA1 bin for '97 V6 Mustang

David Claflin · Post by **David Claflin** » Fri Mar 07, 2008 11:41 am

Does anyone have one or know where one can be had?

David Claflin · Post by **David Claflin** » Tue Mar 11, 2008 9:50 am

I found the CDAN XDF, but still not sure what to use for a BIN. Any suggestions??

Post by **dex** » Wed Mar 26, 2008 7:43 am

E-mail sent.

rpsucilla · Post by **rpsucilla** » Tue Jul 23, 2013 6:07 am

dex wrote:E-mail sent.

Hi can help me with these bin too? have a ford mustang 97 ecu JPA1 I´ve try to read usin the flash and burnII + FA + FE but I can´t be read good because the xdf show me wrong parameters
Thanks.

Post by **dex** » Wed Jul 24, 2013 5:55 am

If you cannot get a good read then the J3 connector may require cleaning.

rpsucilla · Post by **rpsucilla** » Mon Jul 29, 2013 7:37 pm

I´m sure the J3 por is clean because the file always read full 256kb.

only the first time read 56kb, can i upload my bin to you could check it?

Regards.

Post by **dex** » Tue Jul 30, 2013 1:33 am

TunerPro will always read the bin size you set it to but if the J3 is not clean it will read garbage. In addition to the protective grease most J3 connectors are protected with a clean conformal coating.