TunerPro User Forum

i believe the correct settings are data start: 4008 data end: FFFF store address: 4006 store size: 16 bit data size: 8 bit calculation: sum(no carry) I have these settings entered and it is connecting but I am getting a bunch of errors as it is connected. I am also having no luck getting the histor...

is that an E6 truck? i seem to remember the checksum settings being wrong in a few of the XDFs i've seen for it... just set the mask ID to AA and see if it happens again. if so, those settings need fixed. I did this and it seems to be working. Will it be OK leaving it this way or should I change so...

robertisaar wrote:i could probably email you the diagrams and let you figure out if it is feasable...

interested?

Sure! Anything right now could help. Thanks. Gasforblood@comcast.net

Does anyone know if the pinning between the 16168625 and the 16197427 are the same? I have an extra 16197427 ECM and good files to use with it. Would just have to convert over some of the information to the $0D mask. Any thoughts?

Six_Shooter wrote:Using the proper offset?

I am really not sure to tell ya the truth. I am not a pro at this by all means.

Hi I have done a good bit of work with the $OD for my V8 S10 but now I am having problems with my 1993 Chevy C1500 350 TBI. It is running the 16168625. Every time I write a chip and attempt to run it, the check engine light flashes like a strobe light. I could be wrong but I believe that means a bad...

Hi I am looking for a good XDF and ADX file for ECM number 16159278. It is for a 1993 LT1 Trans Am. I am using TunerPro RT V5. that would be DA3, which there are both an XDF and an ADS for on the definitions page. i wouldn't know how complete they are, but if they seem lacking, let me know. The XDF...

Hi I am looking for a good XDF and ADX file for ECM number 16159278. It is for a 1993 LT1 Trans Am. I am using TunerPro RT V5.