Am I right in thinking that v2.01 automatically updates tables in edit mode with the display option that you select via preferences (whereas v2.0 did not)?
Anyhoo, I was editing an ignition advance table in engineering units, and wanted to view it in hex. I went into preferences, selected hex, and the table updated - but not completely correctly (not all cell values were correct). Killing the edit window and re-opening it worked fine.
Keep up the good work,
Robin
P.S. Having been used to the hex/engineering select button in Winbin being out in the open, it's a little frustrating having to go into preferences for it. Maybe I've got in to bad habits, but I do swap between the two quite often.
Conversion between hex and engineering units
Moderators: Mangus, robertisaar, dex
-
- Posts: 15
- Joined: Mon Apr 07, 2003 12:54 pm
-
- Posts: 15
- Joined: Mon Apr 07, 2003 12:54 pm