Just wondering what equipment I need to hook up and tune the Ford ECC-IV & ECC-V ECU?
I have been using TP 5 to tune the Delco computers and I see on the TP website that TP 5 can be used on the Fords
I haven't been able to find any posts on what gear is needed to be able to use TP 5 and if it's posible yet.
Thanks Ben
Hooking up to a ford ECC 4, 5 ECU
Moderators: Mangus, robertisaar, dex
yes you can tune most of the eec4 with a j3 chip available in australia via tiperformance.com.au
the def files and bin files are also located on the site , you can also purchase the burner required to program the j3 chip from there as they are not compatible with moates j3 chips
if you already have the moates burn 2 then you can purchase the chips via moates and program the chips with the f3 j3 adaptor with the tuner pro software
hope that helps
the def files and bin files are also located on the site , you can also purchase the burner required to program the j3 chip from there as they are not compatible with moates j3 chips
if you already have the moates burn 2 then you can purchase the chips via moates and program the chips with the f3 j3 adaptor with the tuner pro software
hope that helps
Also check out the Quarterhorse product at:
http://www.moates.net/quarterhorse-for- ... l?cPath=63
http://www.moates.net/quarterhorse-for- ... l?cPath=63