TunerPro User Forum

Need Bin Definition and Acquisition files for 1987 F-Body 1227165 Tuned Port 5.7 auto engine runs on chip but tables all read zeros someone suggested I am not using the right chip addressing but I cant even read the chip using other settings. Very frustrating. I spend all day to figure out how to ma...

yes I have to the T. This is the instruction Mark gave me and I still didnt get anywhere. The curser sits in the right lower corner and does not move. I had data come up in the dash display setting but thats it as far as data. and may I ad I have version 4 and there are things that differ from this ...

I have been trying to trace data since last Friday and I am not getting to the bottom of why. I have followed Marks instruction to the T but when I expect the trace to work it just sits there. I am also getting mismatch errors when I try to setup definitions and link them to tables. I cannot figure ...

We are having paitence with you, we are answering your questions and trying to help. ;) Read this on offsets: http://support.moates.net/2010/04/05/programming-chips-using-offsets/ I'll PM you my email later. Ok, I read the offset info on moates.net and I pretty confident but not positive that the a...

It also sounds like you're not using the correct offset, when prgramming the new EPROM, or possibly even reading the original EPROM. I'm worried about when you say the stock VE table was "choppy", I've never seen a stock cal, where the VE and even spark tables weren't somewhat smooth. So ...

tuning a 1993 chev camaro LT1 350 using DA3.xdf. successful at reading the bin from the original chip wihich did not have any issues other than a very choppy VE table causing a lean idle to mid range. When I am emulating the copy of the bin, or even reburn it to a new chip I am getting a ses light, ...

Yes, then you need to worry about the XDF... It would be MUCH easier to point you in the right direction if you listed your exact application. Yes, a "hack" or "dissassembly" document is used to create an XDF. ok since your interested, As far as the moates equipment I have an ap...

Yes, then you need to worry about the XDF... It would be MUCH easier to point you in the right direction if you listed your exact application. Yes, a "hack" or "dissassembly" document is used to create an XDF. ok since your interested, As far as the moates equipment I have an ap...

Yes, then you need to worry about the XDF... It would be MUCH easier to point you in the right direction if you listed your exact application. Yes, a "hack" or "dissassembly" document is used to create an XDF. ok since your interested, As far as the moates equipment I have an ap...

If I understand correctly from reading posts, you cannot create a xdf from a bin. so my question is will intended xdf files posted work with all bins already in use or are they propietory to the software being used? I have a chip already installed and I am questioning rather or not the bin and the ...

If I understand correctly from reading posts, you cannot create a xdf from a bin. so my question is will intended xdf files posted work with all bins already in use or are they propietory to the software being used? I have a chip already installed and I am questioning rather or not the bin and the x...