TunerPro User Forum

I have a 1982 Corvette also. Have you been able to get this fully functioning? I am getting a reading, but cannot get the data dash to show graphically while running. I getting ready to have the throttle body bushing put in for the shafts and wanted to get a good reading before I take them off. Tha...

the IAC is a stepper motor used to control the amount of air going into the engine during low to no throttle. think of it as a computer controlled vacuum leak. more steps = more airflow. vacuum(as measured by the MAP sensor), it looks like you're at none if it is showing 4.92 volts. there should be...

the amount of info being limited is normal... a lot of GM vehicles didn't really have ECMs in 1982, and the ones that did were pretty primative in what they could do. i'm not used to a crossfire, but you seem to be idling with a LOT of IAC steps and little to no vacuum. I hear you there!!! Can you ...

1- I completely deleted everything including the cable drivers and started over again... I found out that File XDF View Compare at the top of the menu bar are for rewriting the PROM and not used if not attempting this task, as additional hardware is needed. The ADS file is for Version 4 and needs to...

sure you're trying to load an ADX file when that happens? i think that message will happen when trying to load an ADS in addition to probably most other filetypes. thanks for all of the replies, have to run out, will be back on later tonight, going to hook up to the Vette and see if I can get any r...

sounds like you're opening the XDF, not the XDL. for guages, look for a red circular "guage" icon underneath the navigation bar. should see 4 icons there for the 4 different views. what error message comes up when the ADX is loaded? trying to do to much at one time..... :lol: error messag...

looks like you have the right ADX, logs are recorded as XDLs. did you already get one recorded? you're on the right path. good to hear :lol: ok, the ADX seems fine and once I activated the XDL, then all of the parameters came up on the left side of the screen. I tried to record a log, but don't kno...

i guess, what are you attempting to do? just datalogging(or watching a log?) or changing the calibration? would like datalogging, watch a log, etc., don't want to change the calibration, just want to take advantage of all of the info available and make sure I am setting up the software correctly......

ok, making progress, opened .xdl and the parameter's list, etc., came up.
so I am moving forward

Hello all, newbie to the forum, could use some help. Installed TunerPRO RT, have the ADL cable and trying to figure out how to proceed. 1- I cannot bring up the parameter ordered list, type, or category. so how is that done? 2- I have the A062 adx file in the TunerPro files, I think it is activated,...