TunerPro User Forum

So, I got BIN ))))
But XDF a cant find for it. How I can find paramiters adress in my BIN?

Ok Again I am here
So, what we have:
ECM 16141470
Eprom 16191613
Prom id 1615
scan id 1814
BCC BFJZ

New 3 wire o2 sensor (works perfect)
Nece looking signal from O2 sensor in tuner pro.
No errors in ECM.

But ECM all the time in open loop mode.

What i need to check more deep?

Thank You Gentelmens! I will come back after some tests with mode 4. And when I will find one more PCM for tetst.

you won't damage the ECM using mode 4 commands.... you also won't be able to get trans temp that way either. mode4 controls outputs. what you want is mode2 or mode3 to selectively dump data from RAM. you would need to know what byte in the RAM is being used for trans temp. however, i'm looking at t...

Next question is...
I want to get trans iol temp/ it's not in data sream of mode 1.
How I can get it other way?
If i will try to use this mode 4 commands http://www.thirdgen.org/techboard/diy-p ... 165-a.html
Have i chance to kill my ecu?

Acquisition - Edit Definition - Hit + on Commands - Look at Transmit Data Reply - Look at Body Size(Dec). If it is not, change the value to equal Payload Offset + Payload Size + 1 I connect to ECM by terminal and send standart reqest for mode 1 . In data 64 data bytes +3 + cheksumm.So I correct set...

Hello! I have problem with connection. No errors, but data is corrupted. 0.5s correct value 0/5 second trash. A test a lot of different ADX files. Same problem. I find at this forum about adding delay after reciev data. Put 20ms. Same problem. But when I set 9ms and Transmit Stream Reply delay 200ms...