Problem viewing compare bin

charlescrown · Post by **charlescrown** » Sun Jan 29, 2012 7:14 pm

Hope someone can help.
I am using TunerPro RT and when I use the bin compare feature the bin I an comparing with is nothing like it should be eg timing at 0 instead of the acual 30 degrees.
If I switch them around and use my original bin as the compare bin it now is way off the mark.
In other words I cannot use this feature.
I removed the program thinking it may be a bug reloaded it but still the same.
As I am a beginner to chip tuning any help would be greately appreciated.
Thanks for reading
Dave

EagleMark · Post by **EagleMark** » Tue Jan 31, 2012 3:06 pm

Sounds like your trying to compare a bin with differant mask ID. Both bins have to use the same mask/xdf file.

charlescrown · Post by **charlescrown** » Tue Jan 31, 2012 5:16 pm

No same XDF just 2 different bin files created with that XDF. Weird I know because it did work in the past. Thanks for your input

EagleMark · Post by **EagleMark** » Tue Jan 31, 2012 5:47 pm

Something must have gone wrong with the bin file? Corrupt... got a backup or need one? What BCC?

charlescrown · Post by **charlescrown** » Tue Jan 31, 2012 6:17 pm

The bin file is not corrupted.
All the file is comparable except for the maps. They are all over the place and as I said if I swap them around the compare bin maps are all over the place. On there own all is OK and workable but it's when you compare where the problem is. I must have a setting wrong somewhere.