TunerPro User Forum

I put a e36 iron block 2.8 m52 in a e46 , kept stock e46 dme for dash and can bus etc.. and piggy back a 413 silver label for running the motor with obd1 engine harness and intake manifold, its hooked up im just looking for a stock m52b28 file to run the motor, also I clipped the green wire pin 66 at the dme to disable ews. I plan to turbo the engine later I just want to get it running and work out any issues 1st.

I used tuner pro a couple years ago for a m50 motor with a holset turbo, but something went wrong lol lost all compression in cyl #5 im kind of rusty, if I remember right the xdf or something was not %100 accurate. I still have my moates chip burner and a few chips though

Pm me your Email and I will send you a bin file and a xdf.

can you send me the stock xdf sir ?
my e-mail is eng.alimehrem@hotmail.com

can any one help me here guys i cant reach any member here !!

can any one help me here guys i cant reach any member here !!

Hi,
If someone is still around... I'm looking for exactly what the OP requested [=
love to have the BIN+XDF also.

Thanks!

vw_b@walla.co.il (worth a shoot..)

Its in the download section.

Hi
Thanks evilm3666.
Well.. sorry for being anoying but can you point me for the correct one? I looked through the bin's and couldn't find it :/

Also my situations is little bit different, I'm having an e34 (but also a 413 silver DME), is it matter? maybe a different O2 sensors? I have only 1.

Regards,

soo freak'n busy lately.

anyone still need help ?

Yes
I need a map for the stock m52b28 with the m50 intake. Using the silver 413 dme.
1995 e34, previous engine was the m50b25tu.
Thank you.