TunerPro User Forum

Would anyone be familiar if there are different XDF files to be used with Monster S2R800?
Or any particular setting in TunerPro to be adjusted according bike drawing/year model?

My bike is 2006 model with original ECU and TPS:
Drawing: 28641211B
Hardware: IAW5AMHW610
Omologation: 5AMD5
Software: 2219DZ13
Tester: DUC
Date: 2006.02.15

With TunerPro I'am using XDF file found here:
https://www.von-der-salierburg.de/downl ... _V1.28.zip
Unfortunately that XDF shall bring in my bike BIN with mixed up main fuel table (RPM/TPS).
RPM range is a mess and TPS ending too short (28deg).

I also tested BIN files from other S2R800 bikes found here
https://ecu-repo.spiro-media.de/Ducati- ... i/Monster/
1) s2r800 oem IAW5AM BS HW610 2219 DD007.bin seem to be 1:1 match to my bike and it works fine with XDF/TunerPro.
2) Then again all the rest in that repo are failing exactly as mine does, mixed up RPM range+low TPS range.

I downloaded the BIN from my bike again with GuzziDiag just in case of corrupted file, no change.

I tested with another XDF below, no change exactly same result than earlier.
https://ecu-repo.spiro-media.de/Ducati- ... IAW%205AM/
What might be the reason - any idea?

Tommi

I have an 07 S2R800 and have been using the attached xdf for a few years exclusively for fueling. I'm using larger IWP-069 injectors (scaled down) and running the S2R1000 engine with the 800 ECU. The file name says S4R and 996 but the fuel maps come out clean.

Edit - I also verified in the that the immobilizer switch does edit the hex from 01 to 00 in the address listed in TunerPro.