Calling in from Australia here, and new to the forum.
Firstly, Id like to say thanks to Mark and team for the development of such an awesome application, and for the running of this board. I wish i had the skillsets to be able to contribute to the community like you folks.
Ive been using TunerPro for a little while now as i play around with some P01 ECU's for an FJ40 Landcruiser LS1 conversion i'm doing. Its lots of fun, and a really significant learning curve for me. I'm using PCM Hammer to pull the bin files off the ECU's, then using TunerPro with the relevant XDF files (and DLL), and then rewriting back to the ECU. All good
My boys and I also have a couple of Seadoo Jetskis that we want to start tuning and playing around with also. We have purchased a KTag device to enable us to read the BIN data from the ECU's (Bosch ME17.8.5), with the intent of then perhaps using TunerPro to do the actual tuning. We do have HP Tuners, but with four Seadoo Jetskis (one for each of my boys, and myself), this is a prohibitively expensive exercise (nearly $1200).
The issue of course is that for us to be able to use TunerPro, we would need the accompanying (and relevant) XDF files (and i presume DLL file for checksum purposes?)
So - I was wondering if anyone might be able to point us in the right direction to perhaps download these files, or indeed anyone else to ask.
Much appreciated!