datalogging,map voltage/kpa

907 Chevy · Post by **907 Chevy** » Sun Apr 25, 2010 10:08 pm

Hey,new guy with a question...
I just started logging data from my 95 chevy k1500 and I noticed the map is represented in volts instead of kpa.Is there any changes I can make in tunerpro to make it show map in kpa?

Six_Shooter · Post by **Six_Shooter** » Mon Apr 26, 2010 4:24 am

There is.

You either have to edit the current MAP volts parameter, or add a second parameter so that you still have the option of using volts.

There is information on this site of how to go about do that and what the proper calculation is that you have to enter. I just don't recall what it is off hand.

All of this is done under the "Edit ADX" option found in the Aquisition drop down menu, if you are using V5, or "Edit datastream" found in the set-up datalogging pop up box in V4.

907 Chevy · Post by **907 Chevy** » Tue Apr 27, 2010 5:06 pm

Thanks for the help.
I found the edit datastream option in setup.I'm still trying to figure out the correct formula for converting to kpa...

Post by **robertisaar** » Tue Apr 27, 2010 5:10 pm

i like X * .369 + 10.354

907 Chevy · Post by **907 Chevy** » Tue Apr 27, 2010 6:14 pm

Thank you,sir
Worked like a charm...