No Hardware Found

sepno77 · Post by **sepno77** » Sat Apr 17, 2010 6:45 am

I'm a complete noob and need someone to teach me the way of the TunerPro jedi's.

Problem:
ALDL cable not detected in Tunerpro RT.

Car Info:
1993 Camaro lt1 obd1 serial aldl cable old laptop setup on com port 1.

Six_Shooter · Post by **Six_Shooter** » Sat Apr 17, 2010 6:15 pm

You have adjusted the settings in the ALDL/Emulation Preferences tab, to match what you are using?

sepno77 · Post by **sepno77** » Mon Apr 19, 2010 1:29 pm

It says com port 1. Do I have to hook up the cable to a 12v and ecu in order for this system to detect the cable.

Six_Shooter · Post by **Six_Shooter** » Mon Apr 19, 2010 2:33 pm

If it is a cable that needs external power, then yes, you will need to connect to power, you do not need to nor want to connect to the ECU to use the detect cable function.

sepno77 · Post by **sepno77** » Mon Apr 19, 2010 3:24 pm

Ok. Will try it again tomorrow and get back to you w/ my results.

maisnamvictor · Post by **maisnamvictor** » Fri Jun 04, 2010 9:39 am

I want to know what range of the hardware chips the software will support?
I have installed a custom ECU in my car and want to find out and work tuning the chip DIY.

The ECU has an OBDII port, but I also want to use the OBDII port to the ECU and USB port to connect to my PC, is there any cable available in the market?

Please advice.

TunerPro User Forum

No Hardware Found

No Hardware Found

Software Universal